Netgear XSM4324FS CLI Manual Software Version 12.x - Page 638

M4300 Intelligent Edge Series Fully Managed Stackable Switches ISDP Table Full 392 ISDP IP Address Table Full 737 debug isdp packet This command enables tracing of ISDP packets processed by the switch. ISDP must be enabled on both the device and the interface in order to monitor packets for a particular interface. Note: To display the debug trace, enable the debug console command. Format Mode debug isdp packet [receive | transmit] Privileged EXEC no debug isdp packet This command disables tracing of ISDP packets on the receive or the transmit sides or on both sides. Format Mode no debug isdp packet [receive | transmit] Privileged EXEC Interface Error Disabling and Auto Recovery Commands Interface error disabling automatically disables an interface when an error is detected. No traffic is allowed until the interface is either manually reenabled or, if auto recovery is configured, the configured auto recovery interval expires. If an error condition is detected for an interface, the switch places the interface in an error-disabled state (also referred to as a diagnostic-disabled state) by shutting down the interface. The error-disabled interface does not allow any traffic until the interface is reenabled. You can manually enable the error-disabled interface. Alternatively, you can enable auto recovery, which automatically reenables the interface after the expiration of the configured interval. errdisable recovery cause This command enables auto recovery for a specific cause or for all causes. If auto recovery is enabled, interfaces in the error-disabled state are reenabled when the recovery interval expires. If errors continue on the interface, the interface can be placed back in the error-disabled state and disabled. You can manually reenable an interface in the error-disabled state by entering the no shutdown command for the interface. Switching Commands 638 CLI Command Reference Manual