Netgear XSM4324FS CLI Manual Software Version 12.x - Page 392
spanning-tree port mode, value to a lower number to prefer a port for forwarding of frames.
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 392 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches spanning-tree port mode This command sets the Administrative Switch Port State for this port to enabled for use by spanning tree. Default Format Mode enabled spanning-tree port mode Interface Config no spanning-tree port mode This command sets the Administrative Switch Port State for this port to disabled, disabling the port for use by spanning tree. Format Mode no spanning-tree port mode Interface Config spanning-tree port mode all This command sets the Administrative Switch Port State for all ports to enabled. Default Format Mode enabled spanning-tree port mode all Global Config no spanning-tree port mode all This command sets the Administrative Switch Port State for all ports to disabled. Format Mode no spanning-tree port mode all Global Config spanning-tree port-priority Use this command to change the priority value of the port to allow the operator to select the relative importance of the port in the forwarding process. The value range is 0-240. Set this value to a lower number to prefer a port for forwarding of frames. All LAN ports have 128 as priority value by default. PVSTP/PVRSTP puts the LAN port with the lowest LAN port number in the forwarding state and blocks other LAN ports. The application uses the port priority value when the LAN port is configured as an edge port. Switching Commands 392 CLI Command Reference Manual