Netgear XSM4324FS CLI Manual Software Version 12.x - Page 565
set igmp groupmembership-interval, set igmp maxresponse, show igmpsnooping fast-leave
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 565 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches You can display the operational status of IGMP Snooping fast-leave at port level by using the show igmpsnooping fast-leave command (see show igmpsnooping fast-leave on page 573). Default Format Mode Enabled set igmp fast-leave auto-assignment Global Config set igmp groupmembership-interval This command sets the IGMP group membership interval time on a VLAN, one interface, a range of interfaces, or all interfaces. The group membership interval time is the amount of time in seconds that a switch waits for a report from a particular group on a particular interface before deleting the interface from the entry. This value must be greater than the IGMPv3 maximum response time value. The range is 2 to 3600 seconds. Default Format Mode 260 seconds set igmp groupmembership-interval [vlan-id] seconds Interface Config Global Config VLAN Config no set igmp groupmembership-interval This command sets the IGMPv3 group membership interval time to the default value. Format Mode no set igmp groupmembership-interval [vlan-id] Interface Config Global Config VLAN Config set igmp maxresponse This command sets the IGMP maximum response time for the system, on a particular interface or VLAN, or on a range of interfaces. The maximum response time is the amount of time in seconds that a switch will wait after sending a query on an interface because it did not receive a report for a particular group in that interface. This value must be less than the IGMP query Interval time value. The range is 1 to 300 seconds. Default Format Mode 600 seconds set igmp maxresponse [vlan-id] seconds Global Config Interface Config VLAN Config Switching Commands 565 CLI Command Reference Manual