Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1071

M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: If none of the interfaces are enabled for PIM, the following message is displayed: None of the routing interfaces are enabled for PIM. show ipv6 pim neighbor This command displays PIM neighbors discovered by PIMv2 Hello messages. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter is a number in the range of 1-4093. If the interface number is not specified, this command displays the neighbors discovered on all the PIM-enabled interfaces. Format Modes show ipv6 pim neighbor [{unit/slot/port | vlan vland-id] Privileged EXEC User EXEC Term Neighbor Address Interface Up Time Expiry Time DR Priority Definition The IPv6 address of the PIM neighbor on an interface. unit/slot/port The time since this neighbor has become active on this interface. Time remaining for the neighbor to expire. The DR Priority configured on this Interface (PIM-SM only). Note: DR Priority is applicable only when sparse-mode configured routers are neighbors. Otherwise, NA is displayed in this field. Command example: (NETGEAR) #show ipv6 pim neighbor Neighbor Addr 2001:DB8:39::/32 2001:DB8:A3::/32 Interface --------1/0/1 1/0/2 Uptime (HH:MM::SS) ----------00:02:55 00:03:50 Expiry Time (HH:MM::SS) ----------00:01:15 00:02:10 Command example: If no neighbors were learned on any of the interfaces, the following message is displayed: No neighbors are learnt on any interface. IPv6 Multicast Commands 1071 CLI Command Reference Manual