Netgear XSM4324FS CLI Manual Software Version 12.x - Page 157

M4300 Intelligent Edge Series Fully Managed Stackable Switches Text-based configuration supports TACACS server's secrets in encrypted and non-encrypted format. When you save the configuration, these secret keys are stored in encrypted format only. If you want to enter the key in encrypted format, enter the key along with the encrypted keyword. In the output of the show running-config command (for information about the command, see show running-config on page 212), these secret keys are displayed in encrypted format. You cannot show these keys in plain text format. Format Mode tacacs-server key [key-string | encrypted key-string] Global Config no tacacs-server key Use the no tacacs-server key command to disable the authentication and encryption key for all TACACS+ communications between the switch and the TACACS+ daemon. The key-string parameter has a range of 0-128 characters This key must match the key used on the TACACS+ daemon. Format Mode no tacacs-server key key-string Global Config tacacs-server keystring Use the tacacs-server keystring command to set the global authentication encryption key used for all TACACS+ communications between the TACACS+ server and the client. Format Mode tacacs-server keystring Global Config Command example: (NETGEAR Switch)(Config)#tacacs-server keystring Enter tacacs key:********Re-enter tacacs key:******** tacacs-server source-interface Use this command in Global Configuration mode to configure the source interface (Source IP address) for TACACS+ server configuration. The selected source-interface IP address is used for filling the IP header of management protocol packets. This allows security devices (firewalls) to identify the source packets coming from the specific switch. If a source-interface is not specified, the primary IP address of the originating (outbound) interface is used as the source address. Format Mode tacacs-server source-interface {unit/slot/port | loopback loopback-id | vlan vlan-id} Global Config Management Commands 157 CLI Command Reference Manual