Netgear XSM4324FS CLI Manual Software Version 12.x - Page 23

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 6. CLI Mode Access and Exit (continued) Command Mode Access Method Exit or Access Previous Mode DHCPv6 Pool Config From the Global Config mode, enter ip dhcpv6 pool pool-name. To exit to the Global Config mode, enter exit. To return to the Privileged EXEC mode, enter Ctrl-Z. Stack Global Config Mode From the Global Config mode, enter stack. To exit to the Global Config mode, enter the exit command. To return to the Privileged EXEC mode, enter Ctrl-Z. ARP Access-List Config Mode From the Global Config mode, enter arp To exit to the Global Config mode, enter the access-list. exit command. To return to the Privileged EXEC mode, enter Ctrl-Z. Support Mode From the Privileged EXEC mode, enter support. Note: The support command is available only after you issued the techsupport enable command. To exit to the Privileged EXEC mode, enter exit, or press Ctrl-Z. Command Completion and Abbreviation Command completion finishes spelling the command when you type enough letters of a command to uniquely identify the command keyword. Once you have entered enough letters, press the SPACEBAR or TAB key to complete the word. Command abbreviation allows you to execute a command when you have entered there are enough letters to uniquely identify the command. You must enter all of the required keywords and parameters before you enter the command. CLI Error Messages If you enter a command and the system is unable to execute it, an error message appears. The following table describes the most common CLI error messages. Table 7. CLI Error Messages Message Text Description % Invalid input detected at '^' marker. Indicates that you entered an incorrect or unavailable command. The carat (^) shows where the invalid text is detected. This message also appears if any of the parameters or values are not recognized. Command not found / Incomplete Indicates that you did not enter the required keywords or values. command. Use ? to list commands. Software Modules 23 CLI Command Reference Manual