Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1131

M4300 Intelligent Edge Series Fully Managed Stackable Switches O/S Support Table 69. BSP Log Message Component BSP Message rc = 10 Cause Second message logged at bootup, right after Starting code.... Always logged. Table 70. OSAPI Log Messages Component OSAPI OSAPI OSAPI OSAPI OSAPI OSAPI OSAPI OSAPI OSAPI Message Cause osapiNetLinkNeighDump: could not open socket! - or - ipstkNdpFlush: could not open socket! - or - osapiNetlinkDumpOpen: unable to bind socket! errno = XX Couldn't open a netlink socket. Make sure "ARP Daemon support" (CONFIG_ARPD) is enabled in the kernel, if the reference kernel binary is not being used. ipstkNdpFlush: sending delete failed Failed when telling the kernel to delete a neighbor table entry (the message is incorrect). unable to open /proc/net/ipv6/conf/default/hop_limit IPv6 MIB objects read, but /proc file system is not mounted, or running kernel does not have IPV6 support. osapimRouteEntryAdd, errno XX adding 0xYY to ZZ - or - osapimRouteEntryDelete, errno XX deleting 0xYY from ZZ Error adding or deleting an IPv4 route (listed in hex as YY), on the interface with name ZZ Error code can be looked up in errno.h. l3intfAddRoute: Failed to Add Route - or - l3intfDeleteRoute: Failed to Delete Route Error adding or deleting a default gateway in the kernel's routing table (the function is really osapiRawMRouteAdd()/Delete()). osapiNetIfConfig: ioctl on XX failed: addr: 0xYY, err: ZZ - or - osapiNetIPSet: ioctl on XX failed: addr: 0x%YY Failed trying to set the IP address (in hex as YY) of the interface with name XX, and the interface does not exist. Sometimes this is a harmless race condition (e.g. we try to set address 0 when DHCPing on the network port (dtl0) at bootup, before it's created using TAP). ping: sendto error Trouble sending an ICMP echo request packet for the UI ping command. Maybe there was no route to that network. Failed to Create Interface Out of memory at system initialization time. TAP Unable to open XX The /dev/tap file is missing, or, if not using the reference kernel binary, the kernel is missing "Universal TUN/TAP device driver support" (CONFIG_TUN). Switch Software Log Messages 1131 CLI Command Reference Manual