Netgear XSM4324FS CLI Manual Software Version 12.x - Page 60

M4300 Intelligent Edge Series Fully Managed Stackable Switches ip management source-interface Use this command to specify the source IP address for all applications, including RADIUS, TACACS, DNS, SNTP, SNMP, and SysLog. For the loopback keyword, you can enter a number between 0 and 7. Default Format Mode vlan 1 ip management source-interface {serviceport | vlan number | port unit/slot/port | loopback number} Global Config no ip management Use this command to reset the IPv4 management interface to the default settings. Format Mode no ip management Global Config serviceport ip This command sets the IP address, the netmask, and the gateway of the network management port. You can specify the none option to clear the IPv4 address and mask and the default gateway (that is, reset each of these values to 0.0.0.0). Format Mode serviceport ip {ipaddr netmask [gateway] | none} Privileged EXEC serviceport protocol This command specifies the network management port configuration protocol. If you modify this value, the change is effective immediately. If you use the bootp parameter, the switch periodically sends requests to a BootP server until a response is received. If you use the dhcp parameter, the switch periodically sends requests to a DHCP server until a response is received. If you use the none parameter, you must configure the network information for the switch manually. Format Mode serviceport protocol {none | bootp | dhcp} Privileged EXEC Management Commands 60 CLI Command Reference Manual