Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1029
ip pim rp-address, no ip pim join-prune-interval
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1029 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ip pim join-prune-interval Use this command to set the join/prune interval on the specified interface to the default value. Format Mode no ip pim join-prune-interval Interface Config ip pim rp-address This command defines the address of a PIM Rendezvous point (RP) for a specific multicast group range. Note: This command takes effect only when PIM-SM is configured as the PIM mode. Default Format Mode 0 ip pim rp-address rp-address group-address group-mask [override] Global Config Parameter Description rp-address group-address group-mask override The IP address of the RP. The group address supported by the RP. The group mask for the group address. [Optional] Indicates that if there is a conflict, the RP configured with this command prevails over the RP learned by BSR. Command example: (NETGEAR) (Config) #ip pim rp-address 192.168.10.1 224.1.2.0 255.255.255.0 no ip pim rp-address Use this command to remove the address of the configured PIM Rendezvous point (RP) for the specified multicast group range. Format Mode no ip pim rp-address rp-address group-address group-mask [override] Global Config IP Multicast Commands 1029 CLI Command Reference Manual