Netgear XSM4324FS CLI Manual Software Version 12.x - Page 161

M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: (Config)# show tacacs source-interface TACACS Client Source Interface : loopback 0 TACACS Client Source IPv4 Address : 1.1.1.1 [UP] Configuration Scripting Commands Configuration Scripting allows you to generate text-formatted script files representing the current configuration of a system. You can upload these configuration script files to a PC or UNIX system and edit them. Then, you can download the edited files to the system and apply the new configuration. You can apply configuration scripts to one or more switches with no or minor modifications. Use the show running-config command (see show running-config on page 212) to capture the running configuration into a script. Use the copy command (see copy on page 246) to transfer the configuration script to or from the switch. Use the show command to view the configuration stored in the startup-config, backup-config, or factory-defaults file (see show (Privileged EXEC) on page 214). Use scripts on systems with default configurations; however, you are not prevented from applying scripts on systems with non-default configurations. Scripts must conform to the following rules: • Script files are not distributed across the stack and remain only in the unit that is the master at the time of the file download. • The file extension must be ".scr". • A maximum of ten scripts are allowed on the switch. • The combined size of all script files on the switch shall not exceed 2048 KB. • The maximum number of configuration file command lines is 2000. You can type single-line annotations at the command prompt to use when you write test or configuration scripts to improve script readability. The exclamation point (!) character flags the beginning of a comment. The comment flag character can begin a word anywhere on the command line, and all input following this character is ignored. Any command line that begins with the "!" character is recognized as a comment line and ignored by the parser. The following lines show an example of a script: ! Script file for displaying management access show telnet !Displays the information about remote connections ! Display information about direct connections Management Commands 161 CLI Command Reference Manual