Netgear XSM4324FS CLI Manual Software Version 12.x - Page 662

M4300 Intelligent Edge Series Fully Managed Stackable Switches renew dhcp Use this command to force the DHCPv4 client to immediately renew an IPv4 address lease for a specified interface or VLAN. Note: This command can be used on in-band ports as well as the service or network (out-of-band) port. Format Mode renew dhcp {unit/slot/port | vlan vlan-id} Privileged EXEC renew dhcp service-port Use this command to renew an IP address on a service port. Format Mode renew dhcp service-port Privileged EXEC ip route This command configures a static route. The ipaddr parameter is a valid IP address, and subnetmask is a valid subnet mask. The nexthopip parameter is a valid IP address of the next hop router. Specifying Null0 as nexthop parameter adds a static reject route. The optional preference parameter is an integer (value from 1 to 255) that allows you to specify the preference value (sometimes called administrative distance) of an individual static route. Among routes to the same destination, the route with the lowest preference value is the route entered into the forwarding database. By specifying the preference of a static route, you control whether a static route is more or less preferred than routes from dynamic routing protocols. The preference also controls whether a static route is more or less preferred than other static routes to the same destination. A route with a preference of 255 cannot be used to forward traffic. For the static routes to be visible, you must perform the following steps: • Enable ip routing globally. • Enable ip routing for the interface. • Confirm that the associated link is also up. Default Format Mode preference-1 ip route ipaddr subnetmask [nexthopip | Null0 | interface {unit/slot/port | vlan vlan-id}] [preference] [description description] Global Config Routing Commands 662 CLI Command Reference Manual