Netgear XSM4324FS CLI Manual Software Version 12.x - Page 601
LLDP (802.1AB) Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 601 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches show port-security violation This command displays the source MAC address of the last packet discarded on a locked port. Instead of unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the LAG interface, in which lag-intf-num is the LAG port number. Format Mode show port-security violation {unit/slot/port | lag lag-intf-num} Privileged EXEC Term MAC Address VLAN ID Definition The source MAC address of the last frame that was discarded at a locked port. The VLAN ID, if applicable, associated with the MAC address of the last frame that was discarded at a locked port. LLDP (802.1AB) Commands This section describes the command you use to configure Link Layer Discovery Protocol (LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802 LAN to advertise major capabilities and physical descriptions. The advertisements allow a network management system (NMS) to access and display this information. lldp transmit Use this command to enable the LLDP advertise capability on an interface or a range of interfaces. Default Format Mode disabled lldp transmit Interface Config no lldp transmit Use this command to return the local data transmission capability to the default. Format Mode no lldp transmit Interface Config Switching Commands 601 CLI Command Reference Manual