Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1017
show ip mroute static, parameter, the command displays the following column headings
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1017 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches If you use the summary parameter, the command displays the following column headings in the output table. Term Definition Source IP Addr The IP address of the multicast data source. Group IP Addr The IP address of the destination of the multicast packet. Protocol The multicast routing protocol by which this entry was created. Incoming Interface The interface on which the packet for this source arrives. Outgoing Interface The list of outgoing interfaces on which this packet is forwarded. List show ip mroute static Use this command in Privileged EXEC or User EXEC mode to display all the static routes configured in the static mcast table, if it is specified, or display the static route associated with the particular sourceipaddr. Format Modes show ip mroute static [sourceipaddr] Privileged EXEC User EXEC Parameter Source IP Source Mask RPF Address Preference Description IP address of the multicast source network. The subnetwork mask pertaining to the sourceIP. The IP address of the RPF next-hop router toward the source. The administrative distance for this Static MRoute. Command example: console#show ip mroute static MULTICAST STATIC ROUTES Source IP Source Mask RPF Address Preference 1.1.1.1 255.255.255.0 2.2.2.2 23 IP Multicast Commands 1017 CLI Command Reference Manual