Netgear XSM4324FS CLI Manual Software Version 12.x - Page 138

M4300 Intelligent Edge Series Fully Managed Stackable Switches RADIUS Commands This section describes the commands you use to configure the switch to use a Remote Authentication Dial-In User Service (RADIUS) server on your network for authentication and accounting. The first time that you log in as an admin user, no password is required (that is, the password is blank). As of software version 12.0.9.3, after you log in for the first time, you are required to specify a new password that you must use each subsequent time that you log in. After you specify the new password, you are logged out and then must log in again, using your new password. If you are using a RADIUS or TACAS+ server for authentication, after changing the default password to the new password, make sure that you also change the password in the RADIUS or TACAS+ server so that you can continue to log in to the switch. aaa server radius dynamic-author This command enables Change of Authorization (CoA) functionality and lets you configure the switch from the dynamic authorization local server configuration mode. Format Mode aaa server radius dynamic-author Global Config no aaa server radius dynamic-author This command disables Change of Authorization (CoA) functionality. Format Mode no aaa server radius dynamic-author Global Config auth-type This command specifies the type of authorization that the switch uses for RADIUS clients. The client must match the configured attributes for authorization. Default Format Mode all auth-type {any | all | session-key} Dynamic Authorization Management Commands 138 CLI Command Reference Manual