Netgear XSM4324FS CLI Manual Software Version 12.x - Page 677

M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Gateway(s): 172.26.2.1 show ip route net-prototype This command displays the net prototype routes. The output of the command displays the net prototype routes with a P. Format Mode show ip route net-p Privileged Exec Command example: (NETGEAR Switch) #show ip route net-prototype Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S - Static B - BGP Derived, IA - OSPF Inter Area E1 - OSPF External Type 1, E2 - OSPF External Type 2 N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA External Type 2 S U - Unnumbered Peer, L - Leaked Route, K - Kernel P - Net Prototype P 56.6.6.0/24 [1/1] via 9.0.0.2, 01d:22h:15m, 0/1 P 56.6.7.0/24 [1/1] via 9.0.0.2, 01d:22h:15m, 0/1 show ip route summary This command displays a summary of the state of the routing table. When the optional all keyword is given, some statistics, such as the number of routes from each source, include counts for alternate routes. An alternate route is a route that is not the most preferred route to its destination and therefore is not installed in the forwarding table. To include only the number of best routes, do not use the optional keyword. Format Modes show ip route summary [all] Privileged EXEC User EXEC Term Definition Connected Routes The total number of connected routes in the routing table. Static Routes Total number of static routes in the routing table. RIP Routes Total number of routes installed by RIP protocol. BGP Routes Total number of routes installed by the BGP protocol. External The number of external BGP routes. Internal The number of internal BGP routes. Local The number of local BGP routes. Routing Commands 677 CLI Command Reference Manual