Netgear XSM4324FS CLI Manual Software Version 12.x - Page 977
acl-trapflags, show ip access-lists, ACL rule within an ACL referred to as ACL hit count.
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 977 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches acl-trapflags This command enables the ACL trap mode. Default Format Mode disabled acl-trapflags Global Config no acl-trapflags This command disables the ACL trap mode. Format Mode no acl-trapflags Global Config show ip access-lists Use this command to view summary information about all IP ACLs that are configured on the switch. To view more detailed information about a specific access list, specify the ACL number or name that is used to identify the IP ACL. The command output displays the committed rate, committed burst size, and the number of packets that match a configured ACL rule within an ACL (referred to as ACL hit count). Format Mode show ip access-lists [accesslistnumber | name] Privileged EXEC Term ACL ID/Name Rules Direction Interface(s) VLAN(s) Definition Identifies the configured ACL number or name. Identifies the number of rules configured for the ACL. Shows whether the ACL is applied to traffic coming into the interface (ingress) or leaving the interface (egress). Identifies the interface(s) to which the ACL is applied (ACL interface bindings). Identifies the VLANs to which the ACL is applied (ACL VLAN bindings). If you specify an IP ACL number or name, the following information displays: Note: Only the access list fields that you configure are displayed. Thus, the command output varies based on the match criteria configured within the rules of an ACL. Quality of Service Commands 977 CLI Command Reference Manual