Netgear XSM4324FS CLI Manual Software Version 12.x - Page 63

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition MAC Address Type The MAC address that must be used for in-band connectivity. The choices are the burned in or the Locally Administered address. The factory default is to use the burned in MAC address. DHCPv6 Client DUID The DHCPv6 client's unique client identifier. This row is displayed only when the configured IPv6 protocol is DHCP. IPv6 Autoconfig Mode Whether IPv6 Stateless address autoconfiguration is enabled or disabled. DHCP Client Identifier The client identifier is displayed in the output of the command only if DHCP is enabled with the client-id option on the management interface. Command example: (NETGEAR Switch) #show ip management IPv4 Interface Status Up IPv4 Management Interface vlan 1 IP Address 169.254.100.100 Subnet Mask 255.255.255.0 Method DHCP Routing Mode Enable Default Gateway 0.0.0.0 Source Interface vlan 1 Burned In MAC Address DC:EF:09:D3:2D:48 Locally Administered MAC address 00:00:00:00:00:00 MAC Address Type Burned In IPv6 Management Interface is not Configured. show serviceport This command displays service port configuration information. Format Mode show serviceport • Privileged EXEC • User EXEC Term Interface Status IP Address Subnet Mask Default Gateway Definition The network interface status. It is always considered to be up. The IP address of the interface. The factory default value is 0.0.0.0. The IP subnet mask for this interface. The factory default value is 0.0.0.0. The default gateway for this IP interface. The factory default value is 0.0.0.0. Management Commands 63 CLI Command Reference Manual