Netgear XSM4324FS CLI Manual Software Version 12.x - Page 220

M4300 Intelligent Edge Series Fully Managed Stackable Switches show terminal length Use this command to display all the configured terminal length values. Format Mode show terminal length Privileged EXEC Command example: (NETGEAR Switch) #show terminal length Terminal Length For Current Session 24 For Serial Console 24 For Telnet Sessions 24 For SSH Sessions 24 memory free low-watermark processor Use this command to get notifications when the CPU free memory falls below the configured threshold. A notification is generated when the free memory falls below the threshold. Another notification is generated once the available free memory rises to 10 percent above the specified threshold. To prevent generation of excessive notifications when the CPU free memory fluctuates around the configured threshold, only one Rising or Falling memory notification is generated over a period of 60 seconds. The threshold is specified in kilobytes. The CPU free memory threshold configuration is saved across a switch reboot. Format Mode memory free low-watermark processor threshold Global Config Parameter threshold Description When CPU free memory falls below this threshold, a notification message is triggered. The range is 1-1017416 (the maximum available memory on the switch). The default is 0 (disabled). Switch Services Commands This section describes the switch services commands. Switch services are services that provide support for features such as temperature, power supply status, fan control, and others. Each of these services is platform dependent. (For example, some platforms may have temperature sensors, but no fan controller. Or, others may have both while others have neither.) Utility Commands 220 CLI Command Reference Manual