Netgear XSM4324FS CLI Manual Software Version 12.x - Page 666

M4300 Intelligent Edge Series Fully Managed Stackable Switches encapsulation This command configures the link layer encapsulation type for the packet on an interface or range of interfaces. The encapsulation type can be ethernet or snap. Default Format Mode ethernet encapsulation {ethernet | snap} Interface Config Note: Routed frames are always ethernet encapsulated when a frame is routed to a VLAN. show dhcp lease This command displays a list of IPv4 addresses currently leased from a DHCP server on a specific in-band interface or all in-band interfaces. This command does not apply to service or network ports. Format Modes show dhcp lease [interface unit/slot/port] Privileged EXEC Term IP address, Subnet mask DHCP Lease server State DHCP transaction ID Lease Renewal Rebind Retry count Definition The IP address and network mask leased from the DHCP server The IPv4 address of the DHCP server that leased the address. State of the DHCPv4 Client on this interface The transaction ID of the DHCPv4 Client The time (in seconds) that the IP address was leased by the server The time (in seconds) when the next DHCP renew Request is sent by DHCPv4 Client to renew the leased IP address The time (in seconds) when the DHCP Rebind process starts Number of times the DHCPv4 client sends a DHCP REQUEST message before the server responds Routing Commands 666 CLI Command Reference Manual