Netgear XSM4324FS CLI Manual Software Version 12.x - Page 133
snmptrap ipaddr, snmptrap mode, snmptrap source-interface
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Format Mode snmpv2 snmptrap snmpversion name {ipaddr | ip6addr} {snmpv1 | snmpv2} Global Config snmptrap ipaddr This command assigns a new IP address or host name to a community name. The name can use up to 16 case-sensitive alphanumeric characters. Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using the same IP address, the first entry is retained and processed. All duplicate entries are ignored. Format Mode snmptrap ipaddr name ipaddrold ipaddrnew Global Config snmptrap mode This command activates an SNMP trap. Enabled trap receivers are active (that is, able to receive traps). Format Mode snmptrap mode name {ipaddr | ip6addr} Global Config no snmptrap mode This command deactivates an SNMP trap. Disabled trap receivers are inactive (that is, not able to receive traps). Format Mode no snmptrap mode name {ipaddr | ip6addr} Global Config snmptrap source-interface This command configures the global source interface (that is, the source IP address) for all SNMP communication between the SNMP client and the server. Format Mode snmptrap source-interface {unit/slot/port | loopback loopback-id | tunnel tunnel-id | vlan vlan-id} Global Config Management Commands 133 CLI Command Reference Manual