Netgear XSM4324FS CLI Manual Software Version 12.x - Page 762

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition Authentication Type The OSPF Authentication Type for the specified interface are: none, simple, and encrypt. Metric Cost The cost of the OSPF interface. Passive Status Shows whether the interface is passive or not. OSPF MTU-ignore Indicates whether to ignore MTU mismatches in database descriptor packets sent from neighboring routers. Flood Blocking Indicates whether flood blocking is enabled on the interface. The information below displays only if OSPF is enabled. Term OSPF Interface Type State Designated Router Backup Designated Router Number of Link Events Local Link LSAs Local Link LSA Checksum Prefix-suppression Definition Broadcast LANs, such as Ethernet and IEEE 802.5, take the value broadcast. The OSPF Interface Type will be 'broadcast'. The OSPF Interface States are: down, loopback, waiting, point-to-point, designated router, and backup designated router. The router ID representing the designated router. The router ID representing the backup designated router. The number of link events. The number of Link Local Opaque LSAs in the link-state database. The sum of LS Checksums of Link Local Opaque LSAs in the link-state database. Displays whether prefix-suppression is enabled, disabled, or unconfigured on the given interface. Command example: The following output displays when the OSPF Admin Mode is disabled: (NETGEAR Switch) #show ip ospf interface 1/0/1 IP Address 0.0.0.0 Subnet Mask 0.0.0.0 Secondary IP Address(es OSPF Admin Mode Disable OSPF Area ID 0.0.0.0 OSPF Network Type Broadcast Router Priority 1 Retransmit Interval 5 Hello Interval 10 Dead Interval 40 LSA Ack Interval 1 Transmit Delay 1 Routing Commands 762 CLI Command Reference Manual