Netgear XSM4324FS CLI Manual Software Version 12.x - Page 894

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition Bad Version The number of received OSPF packets whose version field in the OSPF header does not match the version of the OSPF process handling the packet. Virtual Link Not Found The number of received OSPF packets discarded where the ingress interface is in a non-backbone area and the OSPF header identifies the packet as belonging to the backbone, but OSPF does not have a virtual link to the packet's sender. Area Mismatch The number of OSPF packets discarded because the area ID in the OSPF header is not the area ID configured on the ingress interface. Invalid Destination Address The number of OSPF packets discarded because the packet's destination IP address is not the address of the ingress interface and is not the AllDrRouters or AllSpfRouters multicast addresses. No Neighbor at Source The number of OSPF packets dropped because the sender is not an existing neighbor or the Address sender's IP address does not match the previously recorded IP address for that neighbor. NOTE: Does not apply to Hellos. Invalid OSPF Packet The number of OSPF packets discarded because the packet type field in the OSPF header is not Type a known type. Hellos Ignored The number of received Hello packets that were ignored by this router from the new neighbors after the limit has been reached for the number of neighbors on an interface or on the system as a whole. The table in trapflags (OSPF) on page 738 lists the number of OSPF packets of each type sent and received on the interface. show ipv6 ospf lsa-group This command displays the number of self-originated LSAs within each LSA group. Format Modes show ipv6 ospf lsa-group Privileged EXEC User EXEC Term Definition Total self-originated LSAs The number of LSAs the router is currently originating. Average LSAs per The number of self-originated LSAs divided by the number of LSA groups. The number of LSA group groups is the refresh interval (1800 seconds) divided by the pacing interval (configured with the timers pacing lsa-group command) plus two. Pacing group limit The maximum number of self-originated LSAs in one LSA group. If the number of LSAs in a group exceeds this limit, OSPF redistributes LSAs throughout the refresh interval to achieve better balance. Groups For each LSA pacing group, the output shows the range of LSA ages in the group and the number of LSAs in the group. IPv6 Commands 894 CLI Command Reference Manual