Netgear XSM4324FS CLI Manual Software Version 12.x - Page 953

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition Mark IP Precedence The mark/re-mark value used as the IP Precedence for traffic matching this class. This is not displayed if mark ip precedence is not specified. Mirror Copies a classified traffic stream to a specified egress port (physical port or LAG). This can occur in addition to any marking or policing action. It may also be specified along with a QoS queue assignment. Non-Conform Action The current setting for the action taken on a packet considered to not conform to the policing parameters. This is not displayed if policing not in use for the class under this policy. Non-Conform COS The CoS mark value if the non-conform action is set-cos-transmit. Non-Conform DSCP Value The DSCP mark value if the non-conform action is set-dscp-transmit. Non-Conform IP The IP Precedence mark value if the non-conform action is set-prec-transmit. Precedence Value Peak Rate Guarantees a committed rate for transmission, but also transmits excess traffic bursts up to a user-specified peak rate, with the understanding that a downstream network element (such as the next hop's policer) might drop this excess traffic. Traffic is held in queue until it is transmitted or dropped (per type of queue depth management.) Peak rate shaping can be configured for the outgoing transmission stream for an AP traffic class (although average rate shaping could also be used.) Peak Burst Size (PBS). The network administrator can set the PBS as a means to limit the damage expedited forwarding traffic could inflict on other traffic (e.g., a token bucket rate limiter) Traffic that exceeds this limit is discarded. Policing Style The style of policing, if any, used (simple). Redirect Forces a classified traffic stream to a specified egress port (physical port or LAG). This can occur in addition to any marking or policing action. It may also be specified along with a QoS queue assignment. If the Policy Name is not specified this command displays a list of all defined DiffServ policies. The following fields are displayed. Term Policy Name Policy Type Class Members Definition The name of this policy. (The order in which the policies are displayed is not necessarily the same order in which they were created.) The policy type (Only inbound is supported). List of all class names associated with this policy. Command example: The following example includes the mark-cos-as-sec-cos option that is specified in the policy action. (NETGEAR Switch) #show policy-map p1 Policy Name p1 Policy Type In Quality of Service Commands 953 CLI Command Reference Manual