Netgear XSM4324FS CLI Manual Software Version 12.x - Page 645

M4300 Intelligent Edge Series Fully Managed Stackable Switches Link Debounce Commands Link debouncing functions on a per-port basis on physical interfaces. After you configure link debouncing, if the switch receives a link-down notification, the switch starts monitoring the link event by starting a timer with the configured debounce time. Any intermediate link-down and link-up events are ignored hereafter. When the timer expires, link debounce checks if the current state of the link is still down; if so, it forwards a link-down notification to the upper layer applications. You must explicitly enable link debounce per interface with an appropriate debounce timer value, taking into consideration the network topology and the features enabled on the switch, such as LAG or spanning tree. Note: Link debouncing is disabled by default. link debounce time This command configures the debounce time. The possible values for the milliseconds parameter are in the 100-5000 range. Format Mode link debounce time milliseconds Interface Config no link debounce time This command disables the debounce time. Format Mode no link debounce time Interface Config show interface debounce This command displays the flap counts for all interfaces. Format Mode show interface debounce Privileged EXEC Command example: (NETGEAR Switch) #show interface debounce Interface Debounce Time(ms) Flaps ------- 1/0/1 0 0 Switching Commands 645 CLI Command Reference Manual