Netgear XSM4324FS CLI Manual Software Version 12.x - Page 146

M4300 Intelligent Edge Series Fully Managed Stackable Switches no radius server msgauth The no version of this command disables the message authenticator attribute to be used for the specified RADIUS Authenticating server. Format Mode no radius server msgauth [ipaddr | dnsname] Global Config radius server primary This command specifies a configured server that should be the primary server in the group of servers which have the same server name. Multiple primary servers can be configured for each number of servers that have the same name. When the RADIUS client has to perform transactions with an authenticating RADIUS server of specified name, the client uses the primary server that has the specified server name by default. If the RADIUS client fails to communicate with the primary server for any reason, the client uses the backup servers configured with the same server name. These backup servers are identified as the Secondary type. Format Mode radius server primary {ipaddr | dnsname} Global Config Field ip addr dnsname Description The IP address of the RADIUS Authenticating server. The DNS name of the server. radius server retransmit This command configures the global parameter for the RADIUS client that specifies the number of transmissions of the messages to be made before attempting the fall back server upon unsuccessful communication with the current RADIUS authenticating server. When the maximum number of retries are exhausted for the RADIUS accounting server and no response is received, the client does not communicate with any other server. Default Format Mode 4 radius server retransmit retries Global Config Field retries Description The maximum number of transmission attempts in the range of 1 to 15. Management Commands 146 CLI Command Reference Manual