Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1068
no ipv6 pim ssm, table do not display in the command output because they are
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1068 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter default Description Defines the SSM range access list FF3x::/32. no ipv6 pim ssm Use this command to remove the Source Specific Multicast (SSM) range of IP multicast addresses on the router. Format Mode no ipv6 pim ssm {default | group-address group-mask} Global Config show ipv6 pim This command displays the system-wide information for PIM-DM or PIM-SM. Format Modes show ipv6 pim Privileged EXEC User EXEC Note: If the PIM mode is PIM-DM (dense), some of the fields in the following table do not display in the command output because they are applicable only to PIM-SM. Term PIM Mode Interface Interface Mode Operational Status Definition Indicates whether the PIM mode is dense (PIM-DM) or sparse (PIM-SM) unit/slot/port Indicates whether PIM is enabled or disabled on this interface. The current state of PIM on this interface: Operational or Non-Operational. The following example displays PIM Mode - Dense: (NETGEAR) #show ipv6 pim PIM Mode Dense Interface --------1/0/1 1/0/3 Interface-Mode Enabled Disabled Operational-Status Operational Non-Operational IPv6 Multicast Commands 1068 CLI Command Reference Manual