Netgear XSM4324FS CLI Manual Software Version 12.x - Page 864

M4300 Intelligent Edge Series Fully Managed Stackable Switches no area virtual-link retransmit-interval This command configures the default retransmit interval for the OSPF virtual interface on the virtual interface identified by area-id and neighbor. The neighbor parameter is the Router ID of the neighbor. Format Mode no area area-id virtual-link neighbor retransmit-interval Router OSPFv3 Config area virtual-link transmit-delay (OSPFv3) This command configures the transmit delay for the OSPF virtual interface on the virtual interface identified by area-id and neighbor. The neighbor parameter is the Router ID of the neighbor. The range for seconds is 0 to 3600 (1 hour). Default Format Mode 1 area area-id virtual-link neighbor transmit-delay seconds Router OSPFv3 Config no area virtual-link transmit-delay This command configures the default transmit delay for the OSPF virtual interface on the virtual interface identified by area-id and neighbor. The neighbor parameter is the Router ID of the neighbor. Format Mode no area area-id virtual-link neighbor transmit-delay Router OSPFv3 Config auto-cost (OSPFv3) By default, OSPF computes the link cost of each interface from the interface bandwidth. Faster links have lower metrics, making them more attractive in route selection. The configuration parameters in the auto-cost reference bandwidth and bandwidth commands give you control over the default link cost. You can configure for OSPF an interface bandwidth that is independent of the actual link speed. A second configuration parameter allows you to control the ratio of interface bandwidth to link cost. The link cost is computed as the ratio of a reference bandwidth to the interface bandwidth (ref_bw / interface bandwidth), where interface bandwidth is defined by the bandwidth command. Because the default reference bandwidth is 100 Mbps, OSPF uses the same default link cost for all interfaces whose bandwidth is 100 Mbps or greater. Use the auto-cost reference-bandwidth command to change the reference bandwidth, specifying the reference bandwidth in megabits per second (Mbps). For the mbps variable, the reference bandwidth range is 1-4294967 Mbps. IPv6 Commands 864 CLI Command Reference Manual