Netgear XSM4324FS CLI Manual Software Version 12.x - Page 54

M4300 Intelligent Edge Series Fully Managed Stackable Switches Configure the Switch Management CPU To manage the switch over the web management interface or Telnet, you must assign an IP address to the switch management CPU. You can accomplish this task through CLI commands or you can use the ezconfig tool, which simplifies the task. The tool lets you configure the following settings: • The administrator user password and administrator-enable password • The management CPU IP address and network mask • The system name and location information The tool is interactive and uses questions to guide you through the configuration steps. At the end of the configuration session, the tool lets you save the information. To see which information was changed by the ezconfig tool after a configuration session, issue the show running-config command. ezconfig This command sets the IP address, subnet mask, and gateway of the switch. The IP address and the gateway must be on the same subnet. Format Mode ezconfig Privileged EXEC (NETGEAR Switch) #ezconfig EZ Configuration Utility Hello and Welcome! This utility will walk you thru assigning the IP address for the switch management CPU. It will allow you to save the changes at the end. After the session, simply use the newly assigned IP address to access the Web GUI using any public domain Web browser. Admin password is not defined. Do you want to assign the admin password (password length must be in range of 8-64 characters) (Y/N/Q)? y Enter new password:******** Confirm new password:******** The 'enable' password required for switch configuration via the command line interface is currently not configured. Do you want to assign it (password length must be in range of 8-64 characters) (Y/N/Q)? y Management Commands 54 CLI Command Reference Manual