Netgear XSM4324FS CLI Manual Software Version 12.x - Page 886

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition Stub Router Startup Time Remaining This is displayed only if the stub router is in startup stub router mode. The remaining time (in seconds) until OSPF exits stub router mode. Stub Router Duration This row is only listed if the stub router is active and the router entered stub mode because of a resource limitation. The time elapsed since the router last entered the stub router mode. The duration is displayed in DD:HH:MM:SS format. External LSDB Overflow When the number of non-default external LSAs exceeds the configured limit, External LSDB Limit, OSPF goes into LSDB overflow state. In this state, OSPF withdraws all of its self-originated non-default external LSAs. After the Exit Overflow Interval, OSPF leaves the overflow state, if the number of external LSAs has been reduced. External LSA Count The number of external (LS type 5) link-state advertisements in the link-state database. External LSA Checksum The sum of the LS checksums of external link-state advertisements contained in the link-state database. New LSAs Originated The number of new link-state advertisements that have been originated. LSAs Received The number of link-state advertisements received determined to be new instantiations. LSA Count The total number of link state advertisements currently in the link state database. Maximum Number The maximum number of LSAs that OSPF can store. of LSAs LSA High Water Mark The maximum size of the link state database since the system started. Retransmit List Entries The total number of LSAs waiting to be acknowledged by all neighbors. An LSA may be pending acknowledgment from more than one neighbor. Maximum Number The maximum number of LSAs that can be waiting for acknowledgment at any given time. of Retransmit Entries Retransmit Entries The highest number of LSAs that have been waiting for acknowledgment. High Water Mark Redistributing This field is a heading and appears only if you configure the system to take routes learned from a non-OSPF source and advertise them to its peers. Source Shows source protocol/routes that are being redistributed. Possible values are static, connected, BGP, or RIP. Metric The metric of the routes being redistributed. Metric Type Shows whether the routes are External Type 1 or External Type 2. Tag The decimal value attached to each external route. Subnets For redistributing routes into OSPF, the scope of redistribution for the specified protocol. IPv6 Commands 886 CLI Command Reference Manual