Netgear XSM4324FS CLI Manual Software Version 12.x - Page 369
auto-negotiate all, description Interface Config, ip mtu
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 369 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no auto-negotiate This command disables automatic negotiation on a port.Automatic sensing is disabled when automatic negotiation is disabled. Format Mode no auto-negotiate Interface Config auto-negotiate all This command enables automatic negotiation on all ports. Default Format Mode enabled auto-negotiate all Global Config no auto-negotiate all This command disables automatic negotiation on all ports. Format Mode no auto-negotiate all Global Config description (Interface Config) Use this command to create an alpha-numeric description of an interface or range of interfaces. Format Mode description description Interface Config mtu Use the mtu command to set the maximum transmission unit (MTU) size, in bytes, for frames that ingress or egress the interface. You can use the mtu command to configure jumbo frame support for physical and port-channel (LAG) interfaces. The MTU size is a valid integer between 1522-9216 for tagged packets and a valid integer between 1518 - 9216 for untagged packets. Note: To receive and process packets, the Ethernet MTU must include any extra bytes that Layer-2 headers might require. To configure the IP MTU size, which is the maximum size of the IP packet (IP Header + IP payload), see ip mtu on page 665. Switching Commands 369 CLI Command Reference Manual