Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1035

M4300 Intelligent Edge Series Fully Managed Stackable Switches ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter is a number in the range of 1-4093. If no interface is specified, the command displays the status parameters of all PIM-enabled interfaces. Format Modes show ip pim interface [unit/slot/port | vlan vlan-id] Privileged EXEC User EXEC Term Definition Interface unit/slot/port, which is the interface number. Mode Indicates the active PIM mode enabled on the interface is dense or sparse. Hello Interval The frequency at which PIM hello messages are transmitted on this interface. By default, the value is 30 seconds. Join Prune Interval The join/prune interval value for the PIM router. The interval is in seconds. DR Priority The priority of the Designated Router configured on the interface. This field is not applicable if the interface mode is Dense. BSR Border Identifies whether this interface is configured as a bootstrap router border interface. Neighbor Count The number of PIM neighbors learned on this interface. This is a dynamic value and is shown only when a PIM interface is operational. Designated Router The IP address of the elected Designated Router for this interface. This is a dynamic value and will only be shown when a PIM interface is operational. This field is not applicable if the interface mode is Dense. Command example: (NETGEAR) #show ip pim interface Interface 1/0/1 Mode Sparse Hello Interval (secs 30 Join Prune Interval (secs 60 DR Priority 1 BSR Border Disabled Neighbor Count 1 Designated Router 192.168.10.1 Interface 1/0/2 Mode Sparse Hello Interval (secs 30 Join Prune Interval (secs 60 DR Priority 1 BSR Border Disabled IP Multicast Commands 1035 CLI Command Reference Manual