Netgear XSM4324FS CLI Manual Software Version 12.x - Page 926
classofservice trust, cos-queue min-bandwidth, cos-queue strict
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 926 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Disabled Format dante vlan Modes Global Config no dante vlan This command sets the following commands for all member ports of a particular VLAN to the default values: • classofservice trust • cos-queue strict The vlan argument can be a VLAN from 1 to 4093. Format Modes no dante vlan Global Config classofservice trust This command sets the class of service trust mode of an interface or range of interfaces. You can set the mode to trust one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also set the interface mode to untrusted. If you configure an interface to use Dot1p, the mode does not appear in the output of the show running-config command because Dot1p is the default. Default Format Modes dot1p classofservice trust {dot1p | ip-dscp | untrusted} Global Config Interface Config no classofservice trust This command sets the interface mode to the default value. Format Modes no classofservice trust Global Config Interface Config cos-queue min-bandwidth This command specifies the minimum transmission bandwidth (bw) guarantee for each interface queue on an interface, a range of interfaces, or all interfaces. The total number of queues supported per interface is platform specific. A value from 0-100 (percentage of link rate) must be specified for each supported queue, with 0 indicating no guaranteed minimum bandwidth. The sum of all values entered must not exceed 100. Quality of Service Commands 926 CLI Command Reference Manual