Netgear XSM4324FS CLI Manual Software Version 12.x - Page 955

M4300 Intelligent Edge Series Fully Managed Stackable Switches show diffserv service brief This command displays all interfaces in the system to which a DiffServ policy has been attached. The inbound direction parameter is optional. Format Mode show diffserv service brief [in] Privileged EXEC Term DiffServ Mode Definition The current setting of the DiffServ administrative mode. An attached policy is only active on an interface while DiffServ is in an enabled mode. The following information is repeated for interface and direction (only those interfaces configured with an attached policy are shown). Term Interface Direction OperStatus Policy Name Definition unit/slot/port The traffic direction of this interface service. The current operational status of this DiffServ service interface. The name of the policy attached to the interface in the indicated direction. show policy-map interface This command displays policy-oriented statistics information for the specified interface and direction. The unit/slot/port parameter specifies a valid interface for the system. Instead of unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the LAG interface, in which lag-intf-num is the LAG port number. Note: This command is only allowed while the DiffServ administrative mode is enabled. Format Mode show policy-map interface unit/slot/port [in] Privileged EXEC Term Definition Interface unit/slot/port Direction The traffic direction of this interface service. Operational Status The current operational status of this DiffServ service interface. Policy Name The name of the policy attached to the interface in the indicated direction. Quality of Service Commands 955 CLI Command Reference Manual