Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1059

M4300 Intelligent Edge Series Fully Managed Stackable Switches show ipv6 mroute source This command displays the multicast configuration settings that are specific to IPv6 such as flags, timer settings, incoming and outgoing interfaces, RPF neighboring routers, and expiration times of all the entries in the multicast route table for the specified source IP address (source-address). Format Modes show ipv6 mroute source source-address {detail | summary} Privileged EXEC User EXEC If you use the detail keyword, the command displays the following column headings in the output table. Term Source IP Addr Group IP Addr Expiry Time Up Time RPF Neighbor Flags Definition The IP address of the multicast data source. The IP address of the destination of the multicast packet. The time of expiry of this entry in seconds. The time elapsed since the entry was created in seconds. The IP address of the RPF neighbor. The flags associated with this entry. If you use the summary keyword, the command displays the following column headings in the output table. Term Source IP Addr Group IP Addr Protocol Incoming Interface Outgoing Interface List Definition The IP address of the multicast data source. The IP address of the destination of the multicast packet. The multicast routing protocol by which this entry was created. The interface on which the packet for this source arrives. The list of outgoing interfaces on which this packet is forwarded. show ipv6 mroute static Use the show ipv6 mroute static command in Privileged EXEC or User EXEC mode to display all the configured IPv6 multicast static routes. Format Modes show ipv6 mroute static [source-address] Privileged EXEC User EXEC IPv6 Multicast Commands 1059 CLI Command Reference Manual