Netgear XSM4324FS CLI Manual Software Version 12.x - Page 735
maximum-paths OSPF, passive-interface default, no redistribute, no maximum-paths
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 735 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no redistribute This command configures OSPF protocol to prohibit redistribution of routes from the specified source protocol or routers. Format Mode no redistribute {rip | bgp | static | connected} [metric] [metric-type] [tag] [subnets] Router OSPF Config maximum-paths (OSPF) This command sets the number of paths that OSPF can report for a given destination in which maxpaths is platform dependent. Default Format Mode 4 maximum-paths maxpaths Router OSPF Config no maximum-paths This command resets the number of paths that OSPF can report for a given destination back to its default value. Format Mode no maximum-paths Router OSPF Config passive-interface default Use this command to enable global passive mode by default for all interfaces. It overrides any interface level passive mode. OSPF will not form adjacencies over a passive interface. Default Format Mode disabled passive-interface default Router OSPF Config no passive-interface default Use this command to disable the global passive mode by default for all interfaces. Any interface previously configured to be passive reverts to nonpassive mode. Format Mode no passive-interface default Router OSPF Config Routing Commands 735 CLI Command Reference Manual