Netgear XSM4324FS CLI Manual Software Version 12.x - Page 196
switchport, show port, description, show port description
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Field Definition Packets Per The approximate number of packets per second received. This value is an exponentially-weighted Second Received average and is affected by the configured load interval. Packets Per Second Transmitted The approximate number of packets per second transmitted. This value is an exponentially-weighted average and is affected by the configured load interval. Link Flaps The number of up and down events for the link since the switch restarted. Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and seconds since the statistics for this port were last cleared. The display parameters, when the argument is switchport are as follows. Term Definition Packets Received Without Error The total number of packets (including broadcast packets and multicast packets) received by the processor. Broadcast Packets Received The total number of packets received that were directed to the broadcast address. Note that this does not include multicast packets. Packets Received With Error The number of inbound packets that contained errors preventing them from being deliverable to a higher-layer protocol. Packets Transmitted Without Error The total number of packets transmitted out of the interface. Broadcast Packets Transmitted The total number of packets that higher-level protocols requested to be transmitted to the Broadcast address, including those that were discarded or not sent. Transmit Packet Errors The number of outbound packets that could not be transmitted because of errors. Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and seconds since the statistics for this switch were last cleared. show interfaces status Use this command to display interface information, including the description, port state, speed and autonegotiation capabilities. The command is similar to show port all but displays additional fields like interface description and port-capability. The description of the interface is configurable through the existing command description name which has a maximum length of 64 characters that is truncated to 28 characters in the output. The long form of the description can be displayed using show port description. The interfaces displayed by this command are physical interfaces, LAG interfaces and VLAN routing interfaces. Format Mode show interfaces status [unit/slot/port] Privileged EXEC Utility Commands 196 CLI Command Reference Manual