Netgear XSM4324FS CLI Manual Software Version 12.x - Page 339

M4300 Intelligent Edge Series Fully Managed Stackable Switches If you specify the port, the command displays the information in the following table. Term Definition Energy Detect Energy-detect admin mode Energy-detect mode is enabled or disabled Energy-detect operational status Energy detect mode is currently active or inactive. The energy-detect mode may be administratively enabled, but the operational status may be inactive. The possible reasons for the status are described below. Reason for Energy-detect current operational status The energy detect mode may be administratively enabled, but the operational status may be inactive for one of the following reasons: • Port is currently operating in the fiber mode • Link is up. • Admin Mode Disabled If the energy-detect operational status is active, this field displays No energy detected. EEE EEE Admin Mode EEE Admin Mode is enabled or disabled. Transmit Idle Time It is the time for which condition to move to LPI state is satisfied, at the end of which MAC TX transitions to LPI state. The Range is (0 to 429496729). The Default value is 0 Transmit Wake Time It is the time for which MAC / switch has to wait to go back to ACTIVE state from LPI state when it receives packet for transmission. The Range is (0 to 65535).The Default value is 0. Rx Low Power Idle Event Count This field is incremented each time MAC RX enters LP IDLE state. Shows the total number of Rx LPI Events since EEE counters are last cleared. Rx Low Power Idle Duration (Sec) This field indicates duration of Rx LPI state in 10 s increments. Shows the total duration of Rx LPI since the EEE counters are last cleared. Tx Low Power Idle Event Count This field is incremented each time MAC TX enters LP IDLE state. Shows the total number of Tx LPI Events since EEE counters are last cleared. Rx Low Power Idle Duration (Sec) This field indicates duration of Tx LPI state in 10 s increments. Shows the total duration of Tx LPI since the EEE counters are last cleared. Tw_sys_tx (Sec) Integer that indicates the value of Tw_sys that the local system can support. This value is updated by the EEE DLL Transmitter state diagram. Tw_sys Echo (Sec) Integer that indicates the remote system's Transmit Tw_sys that was used by the local system to compute the Tw_sys that it wants to request from the remote system. Tw_sys_rx (Sec) Integer that indicates the value of Tw_sys that the local system requests from the remote system. This value is updated by the EEE Receiver L2 state diagram. Tw_sys_rx Echo (Sec) Integer that indicates the remote systems Receive Tw_sys that was used by the local system to compute the Tw_sys that it can support. Utility Commands 339 CLI Command Reference Manual