Netgear XSM4324FS CLI Manual Software Version 12.x - Page 832
ipv6 neighbor
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 832 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches lifetime values and whether hosts should use the prefix for on-link determination or address auto-configuration. Use the ipv6 nd prefix command to configure these values. The ipv6 nd prefix command allows you to preconfigure RA prefix values before you configure the associated interface address. In order for the prefix to be included in RAs, you must configure an address that matches the prefix using the ipv6 address command. Prefixes specified using ipv6 nd prefix without associated interface address will not be included in RAs and will not be committed to the device configuration. Default Format Mode valid-lifetime-2592000 preferred-lifetime- 604800 autoconfig-enabled on-link-enabled ipv6 nd prefix prefix/prefix_length [{seconds | infinite} {seconds | infinite}] [no-autoconfig off-link] Interface Config no ipv6 nd prefix This command sets prefix configuration to default values. Format Mode no ipv6 nd prefix prefix/prefix_length Interface Config ipv6 neighbor Configures a static IPv6 neighbor with the given IPv6 address and MAC address on a routing or host interface. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter is a number in the range of 1-4093. Format Mode ipv6 neighbor ipv6address {unit/slot/port | vlan vland-id} macaddr Global Config Parameter ipv6address unit/slot/port vlan-id macaddr Definition The IPv6 address of the neighbor. The unit/slot/port for the interface. The VLAN for the interface. The MAC address for the neighbor. IPv6 Commands 832 CLI Command Reference Manual