Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1034
show ip pim ssm, show ip pim interface, parameter are used to specify the VLAN
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1034 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches PIM Mode Sparse Interface --------1/0/1 1/0/3 Interface-Mode Enabled Disabled Command example: Operational-Status Operational Non-Operational The following example shows that PIM is not configured: (NETGEAR) #show ip pim PIM Mode None None of the routing interfaces are enabled for PIM. show ip pim ssm This command displays the configured source specific IP multicast addresses. Format Modes show ip pim ssm Privileged EXEC User EXEC Term Group Address Prefix Length Definition The IP multicast address of the SSM group. The network prefix length. Command example: (NETGEAR) #show ip pim ssm Group Address/Prefix Length 232.0.0.0/8 Command example: If no SSM group range is configured, the command displays the following message: No SSM address range is configured. show ip pim interface This command displays the PIM interface status parameters. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN IP Multicast Commands 1034 CLI Command Reference Manual