Netgear XSM4324FS CLI Manual Software Version 12.x - Page 753

M4300 Intelligent Edge Series Fully Managed Stackable Switches Note: Some of the information below displays only if you enable OSPF and configure certain features. Term Definition Router ID A 32-bit integer in dotted decimal format identifying the router, about which information is displayed. This is a configured value. OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a configured value. RFC 1583 Compatibility Indicates whether 1583 compatibility is enabled or disabled. This is a configured value. External LSDB Limit The maximum number of nondefault AS-external-LSA (link state advertisement) entries that can be stored in the link-state database. Exit Overflow Interval The number of seconds that, after entering overflow state, a router will attempt to leave overflow state. Spf Delay Time The number of seconds between two subsequent changes of LSAs, during which time the routing table calculation is delayed. Spf Hold Time The number of seconds between two consecutive spf calculations. Flood Pacing Interval The average time, in milliseconds, between LS Update packet transmissions on an interface. This is the value configured with the command timers pacing flood on page 736. LSA Refresh Group The size in seconds of the LSA refresh group window. This is the value configured with the Pacing Time command timers pacing lsa-group (OSPF) on page 737. Opaque Capability Shows whether the router is capable of sending Opaque LSAs. This is a configured value. Autocost Ref BW Shows the value of auto-cost reference bandwidth configured on the router. Default Passive Setting Shows whether the interfaces are passive by default. Maximum Paths The maximum number of paths that OSPF can report for a given destination. Default Metric Default value for redistributed routes. Stub Router Configuration When OSPF runs out of resources to store the entire link state database, or any other state information, OSPF goes into stub router mode. As a stub router, OSPF reoriginates its own router LSAs, setting the cost of all nonstub interfaces to infinity. Use this field to set stub router configuration to one of Always, Startup, None. Stub Router Startup Time Configured value in seconds. This row is only listed if OSPF is configured to be a stub router at startup. Summary LSA Metric Override One of Enabled (met), Disabled, in which met is the metric to be sent in summary LSAs when in stub router mode. Default Route Advertise Indicates whether the default routes received from other source protocols are advertised or not. Always Shows whether default routes are always advertised. Routing Commands 753 CLI Command Reference Manual