Netgear XSM4324FS CLI Manual Software Version 12.x - Page 55
Management Commands, CLI Command Reference Manual
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Enter new password:******** Confirm new password:******** Current IPv4 Management Interface: vlan 1 Do you want to set new Management VLAN ID (Y/N/Q)?y VLAN ID: 1 Assigning an IPv4 address to your switch management Current IPv4 Address Configuration Management VLAN ID: vlan 1 IPv4 Address Assignment Mode: None IPv4 Address: 0.0.0.0 Subnet Mask: 0.0.0.0 Gateway: 0.0.0.0 Routing Mode: Enable IPv4 address is not assigned. What do you want to do? C - Configure IPv4 address manually. D - Assign IPv4 address for the switch using DHCP Mode(current IPv4 address will be lost). N - Skip this option and go to the next question. Q - Quit. ? - Help. (C/D/N/Q/?)? c IPv4 Address: 192.168.1.1 Network Mask: 255.255.255.0 Gateway: 192.168.254 Incorrect input! Gateway must be a valid IP address. Try again (Y/N/Q)? y Gateway: 192.168.1.254 Do you want to enable global routing (Y/N)?y Current IPv6 Management Interface: (not configured) Do you want to set new IPv6 Management VLAN ID (Y/N/Q)?y VLAN ID: 1 Assigning management IPv6 address. Current IPv6 Address Configuration IPv6 Address: fe80::abd:43ff:fe71:73c0/64 IPv6 Current state: TENT Address DHCP Mode: Disabled Address Autoconfigure Mode: Disabled EUI64 : Enabled Management Commands 55 CLI Command Reference Manual