Netgear XSM4324FS CLI Manual Software Version 12.x - Page 853
show ipv6 vlan, show ipv6 traffic
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 853 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches REDIR (Router Redirect - ICMP type 137): RA Redir ------- ------- 0 0 6599 show ipv6 vlan This command displays IPv6 VLAN routing interface addresses. Format Modes show ipv6 vlan Privileged EXEC User EXEC Term MAC Address used by Routing VLANs Definition Shows the MAC address. The rest of the output for this command is displayed in a table with the following column headings. Column Headings Definition VLAN ID The VLAN ID of a configured VLAN. Logical Interface The interface in unit/slot/port format that is associated with the VLAN ID. IPv6 Address/Prefix Length The IPv6 prefix and prefix length associated with the VLAN ID. show ipv6 traffic Use this command to show traffic and statistics for IPv6 and ICMPv6. Specify a logical, loopback, or tunnel interface to view information about traffic on a specific interface. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter is a number in the range of 1-4093. If you do not specify an interface, the command displays information about traffic on all interfaces. Format Mode show ipv6 traffic [{unit/slot/port | vlan vlan-id | loopback loopback-id | tunnel tunnel-id}] Privileged EXEC IPv6 Commands 853 CLI Command Reference Manual