Netgear XSM4324FS CLI Manual Software Version 12.x - Page 443
Precision Time Protocol Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 443 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Precision Time Protocol Commands This section describes the commands you use to configure the Precision Time Protocol (PTP) end-to-end (E2E) transparent clock. ptp clock e2e-transparent This command enables the PTP E2E transparent clock at system level (that is, globaly) or for an interface. Default Format Mode Enabled at system level and for all interfaces ptp clock e2e-transparent Global Config Interface Config In Global Config mode, the command applies the PTP transparent clock configuration to all physical ports and LAG on the switch. In Interface Config mode, the command provides a next-level control so you can disable this feature selectively for an individual physical port or LAG. You can configure the PTP transparent clock for physical ports and LAGs, but not for a VLAN. When you configure the PTP transparent clock on a LAG, the configuration is applied to all member ports. no ptp clock e2e-transparent This command disables the PTP E2E transparent clock at system level or for an interface. Format Mode no ptp clock e2e-transparent Global Config Interface Config show ptp clock e2e-transparent Use this command to display the operational and configuration status of the PTP E2E transparent clock, both at system level and at interface level. Format Mode show ptp clock e2e-transparent Privileged Exec Term Interface Definition The interface on which the feature is configured. Switching Commands 443 CLI Command Reference Manual