Netgear XSM4324FS CLI Manual Software Version 12.x - Page 435
mode dot1q-tunnel
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 435 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no dvlan-tunnel ethertype primary-tpid Use the no form of the command to reset the TPID register to 0. (At initialization, all TPID registers will be set to their default values.) Format Mode no dvlan-tunnel ethertype {802.1Q | vman | custom 1-65535} [primary-tpid] Global Config mode dot1q-tunnel This command is used to enable Double VLAN Tunneling on the specified interface. Default Format Mode Disabled mode dot1q-tunnel Interface Config no mode dot1q-tunnel This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN Tunneling is disabled. Format Mode no mode dot1q-tunnel Interface Config mode dvlan-tunnel Use this command to enable Double VLAN Tunneling on the specified interface. Note: When you use the mode dvlan-tunnel command on an interface, it becomes a service provider port. Ports that do not have double VLAN tunneling enabled are customer ports. Default Format Mode Disabled mode dvlan-tunnel Interface Config Switching Commands 435 CLI Command Reference Manual