Netgear XSM4324FS CLI Manual Software Version 12.x - Page 628
MAC Database Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 628 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no auto-dos This command disables Auto-DoS on the switch. Format Mode no auto-dos Global Config show auto-dos The output of this command shows whether Auto-DoS is enabled on the switch. Format Mode show auto-dos Global Config MAC Database Commands This section describes the commands you use to configure and view information about the MAC databases. bridge aging-time This command configures the forwarding database address aging time-out in seconds. The seconds parameter must be within the range of 10 to 1,000,000 seconds. In an SVL system, the [fdbid/all] parameter is not used and will be ignored if entered. In an SVL system, the [fdbid/all] parameter is not used and will be ignored if entered. Default Format Mode 300 bridge aging-time seconds Global Config no bridge aging-time This command sets the forwarding database address aging time-out to the default value. In an SVL system, the [fdbid/all] parameter is not used and will be ignored if entered. Format Mode no bridge aging-time Global Config Switching Commands 628 CLI Command Reference Manual