Netgear XSM4324FS CLI Manual Software Version 12.x - Page 671

M4300 Intelligent Edge Series Fully Managed Stackable Switches show ip protocols This command lists a summary of the configuration and status for each unicast routing protocol that is running. The command lists routing protocols that are configured and enabled. If you specify a protocol, the command output is limited to the protocol. Format Mode show ip protocols [ospf | rip] Privileged Exec Term Description OSPFv2 output Routing Protocol OSPFv2. Router ID The router ID configured for OSPFv2. OSPF Admin Mode Whether OSPF is enabled or disabled globally. Maximum Paths The maximum number of next hops in an OSPF route. Routing for Networks The address ranges configured with an OSPF network command. Distance The administrative distance (or "route preference") for intra-area, inter-area, and external routes. Default Route Advertise Whether OSPF is configured to originate a default route. Always Whether the default advertisement depends on a default route in the common routing table. Metric The configured metric that is advertised with the default route. Metric Type The metric type for the default route. Redist Source The type of routes that OSPF is redistributing. Metric The metric that is advertised for redistributed routes. Metric Type The type of metric that is advertised for redistributed routes. Subnets Whether OSPF redistributes subnets of classful addresses or only classful prefixes. Dist List A distribution list that is used to filter routes. Only routes that pass the distribution list are redistributed. Number of Active The number of OSPF areas with at least one active interface and broken down by area type. Areas ABR Status Whether the switch functions as an area border router. A switch functions as an area border router if it includes interfaces that are up in more than one area. ASBR Status Whether the switch functions as an autonomous system boundary router. A switch functions as an ASBR if it is redistributing any routes or originating a default route. RIP output RIP Admin Mode Whether RIP is globally enabled. Routing Commands 671 CLI Command Reference Manual