Netgear XSM4324FS CLI Manual Software Version 12.x - Page 949

M4300 Intelligent Edge Series Fully Managed Stackable Switches DiffServ Service Commands Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you specified by using the policy commands, to an interface in the incoming direction The service commands attach a defined policy to a directional interface. You can assign only one policy at any one time to an interface in the inbound direction. DiffServ is not used in the outbound direction. This set of commands consists of service addition or removal. The CLI command root is service-policy. service-policy This command attaches a policy to an interface in the inbound direction as indicated by the in parameter, or the outbound direction as indicated by the out parameter, respectively. The policyname parameter is the name of an existing DiffServ policy. This command causes a service to create a reference to the policy. Note: This command effectively enables DiffServ on an interface in the inbound direction. There is no separate interface administrative mode command for DiffServ. Note: This command fails if any attributes within the policy definition exceed the capabilities of the interface. Once a policy is successfully attached to an interface, any attempt to change the policy definition, that would result in a violation of the interface capabilities, causes the policy change attempt to fail. Format Modes service-policy {in | out} policymapname Global Config Interface Config Note: Each interface can have one policy attached. no service-policy This command detaches a policy from an interface in the inbound direction as indicated by the in parameter, or the outbound direction as indicated by the out parameter, respectively. The policyname parameter is the name of an existing DiffServ policy. Quality of Service Commands 949 CLI Command Reference Manual