Netgear XSM4324FS CLI Manual Software Version 12.x - Page 451

M4300 Intelligent Edge Series Fully Managed Stackable Switches no set garp timer join This command sets the GVRP join time to the default and only has an effect when GVRP is enabled. Format Mode no set garp timer join Interface Config Global Config set garp timer leave This command sets the GVRP leave time for one interface, a range of interfaces, or all interfaces or all ports and only has an effect when GVRP is enabled. Leave time is the time to wait after receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert registration for the same attribute in order to maintain uninterrupted service. The leave time is 20 to 600 centiseconds. The value 60 centiseconds is 0.6 seconds. The leave time must be greater than or equal to three times the join time. Default Format Mode 60 set garp timer leave centiseconds Interface Config Global Config no set garp timer leave This command sets the GVRP leave time on all ports or a single port to the default and only has an effect when GVRP is enabled. Format Mode no set garp timer leave Interface Config Global Config set garp timer leaveall This command sets how frequently Leave All PDUs are generated. A Leave All PDU indicates that all registrations will be unregistered. Participants would need to rejoin in order to maintain registration. The value applies per port and per GARP participation. The time may range from 200 to 6000 centiseconds. The value 1000 centiseconds is 10 seconds. You can use this command on all ports (Global Config mode), or on a single port or a range of ports (Interface Config mode) and it only has an effect only when GVRP is enabled. The leave all time must be greater than the leave time. Switching Commands 451 CLI Command Reference Manual