Netgear XSM4324FS CLI Manual Software Version 12.x - Page 875
ipv6 ospf cost, ipv6 ospf dead-interval, is, 4. A valid value
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 875 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches ipv6 ospf cost This command configures the cost on an OSPF interface or range of interfaces. The cost parameter has is in the range of 1 to 65535. Default Format Mode 10 ipv6 ospf cost cost Interface Config no ipv6 ospf cost This command configures the default cost on an OSPF interface. Format Mode no ipv6 ospf cost Interface Config ipv6 ospf dead-interval This command sets the OSPF dead interval for the specified interface or range of interfaces. The value for seconds is a valid positive integer, which represents the length of time in seconds that a router's Hello packets have not been seen before its neighbor routers declare that the router is down. The value for the length of time must be the same for all routers attached to a common network. This value should be some multiple of the Hello Interval (that is, 4). A valid value for seconds is in the range from 1-65535. Default Format Mode 40 ipv6 ospf dead-interval seconds Interface Config no ipv6 ospf dead-interval This command sets the default OSPF dead interval for the specified interface or range of interfaces. Format Mode no ipv6 ospf dead-interval Interface Config ipv6 ospf hello-interval This command sets the OSPF hello interval for the specified interface. The value for seconds is a valid positive integer, which represents the length of time in seconds. The IPv6 Commands 875 CLI Command Reference Manual