Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1128

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 66. DVMRP Log Messages (continued) Component DVMRP DVMRP Message Cause DVMRP Prune Control message Send Failed; rtrIfNum - xxx. Neighbor - %s, SrcAddr - %s, GrpAddr - %s DVMRP Prune control message send failed. This could mostly be because of a Failure return status of the socket call sendto(). As a result of this, the unwanted multicast traffic is still received and forwarded. DVMRP Probe Control message Send Failed on rtrIfNum -xxx. DVMRP Probe control message send failed. This could mostly be because of a Failure return status of the socket call sendto(). As a result of this, the DVMRP neighbor could be lost in the neighboring DVMRP routers. Stacking Table 67. EDB Log Message Component EDB Message EDB Callback: Unit Join: num. Technologies Cause Unit num joined the stack. Table 68. Error Messages Component OS OS OS OS Message Cause Invalid USP unit = x, slot = x, port = x A port was not able to be translated correctly during the receive. In hapiBroadSystemMacAddress call to 'bcm_l2_addr_add' - FAILED : x Failed to add an L2 address to the MAC table. This should only happen when a hash collision occurs or the table is full. Failed installing mirror action - rest of the policy applied successfully A previously configured probe port is not being used in the policy. The release notes state that only a single probe port can be configured. Policy x does not contain rule x The rule was not added to the policy due to a discrepancy in the rule count for this specific policy. Additionally, the message can be displayed when an old rule is being modified, but the old rule is not in the policy. Switch Software Log Messages 1128 CLI Command Reference Manual